Publicidad
Idiomas disponibles
Idiomas disponibles
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all acces-
sories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use
the device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resist-
ant surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may
emit a light odor during the first few uses. This is normal and
does not indicate any defect or hazard. Make sure the appli-
ance is well ventilated.
Operating instructions
• Always stand in front of the appliance in such a way that the
control panel can be easily reached.
• Check if the motor unit is switched off and unplug it.
• Place the ingredients in the jar.
• Close the lid firmly.
• Place the jar onto the motor unit.
• Plug the appliance into mains.
• Switch on the motor unit.
• NOTE: Always start at low speed.
• The "power-button" on the motor unit lets the appliance run
continuously at the variable speed determined setting of the
"speed dial".
• Turn the speed dial clockwise for increasing the speed and
counter clockwise for decreasing the speed.
• The "Pulse-button" on the motor unit lets the motor run at
full speed. The motor stops if the button is released.
• Switch off the motor and wait until the motor comes to a
complete stop before removing the container.
• The motor will automatically shut down if the jar is removed.
• Unplug the appliance from the outlet when not in use.
WARNING! Never place the jar on a switched-on motor unit.
This will damage the clutch on the motor unit and on the jar.
Only place the container onto the motor unit if the motor is
switched off.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the
power supply and cool down before storage, cleaning &
maintenance.
• Do not use water jet or steam cleaner for cleaning and do
not push the appliance under the water as the parts will get
wet and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed
from the appliance. If the appliance is not cleaned proper-
ly, it will reduce its lifespan and may result in a dangerous
condition during use.
• DANGER OF INJURY! Care should be taken when handling
the sharp cutting blades during cleaning.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned
before and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for clean-
ing. Do not use petrol or solvents!
• No parts are dishwasher safe.
Maintenance
• Check the operation of the appliance regularly to prevent
serious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact
the supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or rec-
ommended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
Possible cause
Appliance doesn't
No power
work
Knife has been
jammed
Appliance over-
heated
The jar is not
placed on the
motor unit
GB
Possible solution
Check if the plug
is connected to
mains.
Push the reset
button on the
underside of the
motor unit.
Remove the plug
from mains and
let the appliance
cool down
Switch the
appliance of and
place the jar on
the motor unit
and try again
11
Publicidad
