LUND 67110 Manual De Instrucciones página 13

pushing and holding the locking button and then changing the length. Releasing the pressure on the button and then slightly pull-
ing the pipe will trigger the lock and set the length of the pipe, and the sound of the ratchet mechanism will be heard.
Floor and carpet brush - universal brush for cleaning both carpets and all types of hard fl oors. The brush is equipped with a lever
that allows the bristles to be pushed in and out. Pressing the lever in place of the bristle brush symbol pushes the bristles out.
Pressing the lever in place of the brush symbol without bristles pushes the bristles in.
Mop brush - brush for dry cleaning of hard fl oors. Enables you to clean hard fl oors more thoroughly and faster than with a brush.
Slide the rubber bands of the mop cover over the ends of the brush. The mop cover can be washed in automatic washing machines,
at temperatures up to 40 O C. Do not dry clean. Do not dry at low temperatures. Iron at a temperature of 110 degrees. Do not bleach.
3 in 1 crevice brush - allows for cleaning in narrow crevices. The brush is equipped with a double-sided cover with long and short
bristles. Slide the cover onto the end of the brush so that the cover opening locks with the brush latch (X).
Wall bracket - allows you to hang the vacuum cleaner on the wall during storage. The bracket should be fi xed to the wall with two screws.
Using the appliance
After installing the dust container and the selected accessories, make sure that the switch is in the "off " position - O, plug the power
cord plug into the socket. Turn the vacuum cleaner on by moving the switch to the "on" position - I, and start cleaning.
The device is switched off when the switch is set to the "off " position - O.
Control the amount of impurities in the container during operation. The container has an indicator of the maximum level of impuri-
ties marked "Max". Place the container vertically with the lid downwards and check the amount of impurities. Empty the container,
if necessary.
MAINTENANCE AND STORAGE
CAUTION! Never immerse the vacuum cleaner in water or other liquids. Doing so may result in electric shock.
After cleaning, turn off the vacuum cleaner with the switch, disconnect the power cord plug from the socket, disconnect the ac-
cessories and proceed with maintenance.
Disconnect the dust container from the vacuum cleaner. Open the lower cover of the container and discharge the waste collected in the
container. Open the top cover, remove both fi lters. Clean the container with a damp, soft cloth, then dry with a dry cloth or allow to dry.
Warning! It is forbidden to use the vacuum cleaner with a wet or damp fi lter. This can result in electric shock.
The plastic fi lter can be rinsed under running, lukewarm water. Next dry with a dry cloth and allow to dry completely. Wait at least
24 hours after placing the fi lter in a well-ventilated place at room temperature.
Do not wash fi lters in mechanical dishwashers and do not dry them with a stream of hot air. This can cause deformation of the
plastic material used for the construction of the fi lter. Avoid exposing the fi lters to direct sunlight.
No other part of the vacuum cleaner must be exposed to water. Gently tap the internal fi lter to shake off larger impurities. In the
case of excessive contamination, replace the fi lter with a new one.
Clean the remaining parts of the vacuum cleaner with a cloth slightly soaked in water, then dry or allow to dry.
The vacuum cleaner can be stored on a wall bracket. The accessories can be connected or disconnected from the vacuum cleaner
for storage. Store the vacuum cleaner with the power cord's plug disconnected from the socket.
TECHNICAL PARAMETERS
Parameter
Catalogue No.
Rated voltage
Rated frequency
Rated power
Electrical protection class
Dust container capacity
Power cord length
Weight
O R I G I N A L
GB
Units
[V~]
[Hz]
[W]
[l]
[m]
[kg]
I N S T R U C T I O N S
Value
67110
220 – 240
50/60
800
II
1
4.8
1.2
13