YATO YG-04700 Manual De Instrucciones página 8

GB
PRODUCT CHARACTERISTICS
Induction cooker is intended for heating, cooking and preparing of dishes in the vessels designed for use in induction cookers.
With the power adjustment you can adjust the parameters of the cooker to suit your needs. Correct, reliable, and safe operation
of the device is dependent on its proper use, therefore:
Prior to working with the product, you should read all the instruction and keep it around.
For any damages or injuries caused by the product misuse, non compliance with with safety regulations and recommendations
included in this manual, the supplier does not accept any liability. Using the product incorrectly, results also in the loss of user's
rights to the guarantee, as well as a warranty.
EQUIPMENT
The cooker is supplied in a complete state and requires no assembly. Before using the product you should, however, remove all
packaging and protection for transport. They are also required preparatory steps described later in this manual.
GENERAL RECOMMENDATIONS FOR USE
The product has been designed for professional use and its operation should be carried out
by properly qualifi ed personnel. The product is only used for heating, cooking and dishes
preparing in the vessels intended for use in induction cookers. It is forbidden to use the
device in another capacity, place the food directly on the hotplate. It is forbidden to repair
independently, disassembly or modifi cation of the product. Any repairs must be carried out
by an authorized repair service. During the operation, you should supervise the product all
the time. WARNING! During its operation the product heats up to high temperatures, you
should not touch the walls of the product during its operation, it can cause serious burns. The
product is not intended for use by children at least 8 years of age and persons with reduced
physical abilities, mental abilities and people with lack of experience and knowledge of the
equipment. Unless there will be supervised or instruction will be carried out regarding the
use of the product in a safe manner so, so that the associated risks would be understood.
Children should not play with the product. Children without supervision should not carry out
the cleaning and maintenance of the device.
Recommendations for transport and installation of the product
ATTENTION! Installation and connection of the product may be made only by qualifi ed
personnel. The product may only be placed on a hard, fl at, even and non-fl ammable sur-
face. The substrate should withstand the weight of the device, and a vessel placed on it.You
should provide space for at least 10 cm around the lateral walls of the product, do not place
materials that are not resistant to high temperatures above the product. This will allow for
proper ventilation of the product. Do not place eg. a table near the edge. Any electrical de-
vices should be placed above the product. During operation water vapor is released, it can
cause an electrical short circuit and cause electric shock. It is forbidden to drill any holes in
the product, as well as any other product modifi cation, which is not described in the manual.
Product may be transported only in the cold state, by grabbing it by its case. Do not transport
the product by pulling on the power supply cord. On the back of the product and in its vicinity
you should not put any metal objects and surfaces. The temperature at the place of instal-
lation and operation of the product must be in the range of + 10 C ÷ +38 C, and relative
O O
humidity must be below 90% without condensation of water vapor.
O R I G I N A L I N S T R U C T I O N S
8