Publicidad
Idiomas disponibles
Idiomas disponibles
Power Cord Connection
First, insert one end of power cord cable into the power input jack of the monitor,
and another end into the power outlet.
Power On
Turn on the monitor and computer, the indicator will light green ( or blue ) when the
screen is under normal condition. Please check to see if there is any wrong with
the connection of video signal cable if the indicator lights red.
Self-Inspection
If the monitor inspects that there is no horizontal and vertical signal, it will prompt
to check the video input,please refer to the illustration below, and the monitor will
enter into power saving mode after several seconds,the indicator will light red. The
screen will restore to normal display once receiving video signal.
Image Adjustment
Please adjust the image according to your need; please refer to the "Operation" in
Section Three.
OPERATION
Function Keys
A. AUTO/SELECT KEY
When with only VGA mode: without OSD menu, this key is used to auto-adjust, to
adjust the geometrical setting to the best condition. Under OSD menu, this key is
used as confirmation. Under VGA+DVI mode, this key is used to switch the signal
between VGA and DVI.
B. +/- or >/< KEY
In the OSD menu, these two keys are used to scan and select the menu on the left
or right and the volume setting. If the monitor does not have any audio signal press
-/<, this can be used as a shortcut key for brightness; if the monitor does not have
any audio signal function press +/- or >/<, this is only used for adjusting the volume.
C. MENU KEY
Menu Key is use to enter into menu and exit from menu.
Publicidad
