LUND 67230 Manual De Instrucciones página 10

Device operation
Keep the nozzle outlet close to the ironed fabric. Move the nozzle in a smooth motion. Avoid prolonged steaming of one spot, this
can lead to excessive wetting of the fabric and, in consequence, its damage. It is best to iron creases which are diffi cult to remove
by moving the steam jet over them several times, as opposed to doing it once, but more intensively.
Do not use the device as a steam cleaner, for cleaning ceramic surfaces, glass, mirrors, etc.
After ironing, clothing may be slightly damp and warm, wait until it dries and cools down.
Do not use a steam cleaner to iron fabrics which are not intended for ironing. Before using the device, check the garment label, if
there is a crossed-out iron symbol on it, this means that the garment cannot be ironed.
Do not iron leather clothes, artifi cial and natural fur. Do not use the device for ironing, cleaning or disinfecting the upholstery.
During operation, the amount of water in the tank must be constantly monitored. If the capacity of the device decreases, it may
mean that the water in the tank has to be replenished. Do not allow an empty water tank to be heated. This can lead to damage
to the device, or result in an electric shock or fi re.
MAINTENANCE AND STORAGE
After use, disconnect the product from the power supply by pulling out the power cord plug and wait until the water in the tank has
cooled down completely. Empty the water tank. Leave the device with the inlet stopper removed until the remaining water from the
tank has been completely dried. Fit the stopper after the tank has been dried.
Remove the caps from the nozzle and dry separately.
Clean the housing of the unit with a slightly damp cloth, then dry or leave to dry. Never immerse the device housing in water or
other liquids. Do not use alcohol, solvents, corrosive or abrasive agents for cleaning.
Do not use sharp objects to unclog the nozzles. Clogged nozzles must be replaced with new nozzles before further use.
Store the product in dry, shaded and well ventilated places. The place of storage should protect the device from access by unau-
thorised persons, especially children. It is recommended to store the product in the packaging it was delivered in.
TECHNICAL DATA
Parameter
Cat. No.
Rated voltage
Rated frequency
Rated power
Water tank capacity
Maximum steam temperature
Capacity
Ingress protection rating
Protection class
Weight
O R I G I N A L
10
GB
Units
[V~]
[Hz]
[W]
[l]
[OC]
[g/min]
[kg]
I N S T R U C T I O N S
Value
67230
220 - 240
50
1300
0.4
110
22
IPX4
I
0.4