Publicidad
Operation
•
Power supply: 220-240V~, 50Hz, 2000W
Control panel:
•
Window
PTC
Anti-
open
power
frost
detection
setting
Wee
Panel
k day
heatin
g
•
Please connect the unit to the power supply and then press the On/Off switch (O/I) on the left side of
the unit. An acoustic signal will sound and the display will turn on for ten seconds. If you want to switch
off the unit, please press the On/Off switch again.
Please press the On/Standby button on the display to switch on the heating function.
•
Note: The button illumination goes out in 10 seconds if the appliance is not operated. The button
illumination can be reactivated by touching any button.
Please press the On/Standby button on the display again to deactivate the heating function and put the
appliance in standby mode.
Note: Motor will continue working for extra 30s to drive away the residue heat inside unit before
turning off.
•
Day and time setting:
When the heater is ON, long press the button „
o
d1 (Monday).
Use the buttons „+" and „-" to choose among d1（Mon.）, d2 (Tue.), d3 (Wed.), d4（Thur.）,
d5 (Fri.), d6 (Sat.), d7 (Sun.) The selected day flashes. Please press „
Example: Monday -> d1
o
After confirming the day, the hour indication of the clock flashes:
Use the buttons „+" and „-" to set the current hour and confirm with „
indication flashes:
o
The display now shows the time and current day of the week.
•
Power setting:
Function
High heating level
Low heating level
Towel heating function
High heating level +
Towel heating function
o
High heating level (1800W): Please press the on/standby button
Body
senso
r
. Set the current minutes and confirm with „
Power
1800W
1100W
200W
1800W + 200W
= 2000W
Increase in value (+)
24h Timer
Mode setting
Program setting
On/Standby
Heating level selection
Window sensor/
Tower heating
Decrease of value (-)
". The display shows the days of the week
Display symbol
" to confirm.
". Next, the minute
".
to activate the heating
Publicidad
