MSW Motor Technics PROLIFTOR 600 Manual De Instrucciones página 31

BLOCK ASSEMBLY
The device is equipped with an additional accessory, which is a block. The use of the
block allows
In order to assemble the block to the cable:
a) Unscrew and remove the block fasteners (B).
b) Guide the carrying cable with the hook (B) through the belt pulley.
c) Attach all block parts (B).
d) Check the correctness of assembly, tighten any loose parts.
e) Attach the hook (4) of the carrying cable to the dedicated holder located at the
bottom of the winch (C).
CAUTION! All installation work should be carried out with the device disconnected from
the power supply!
3.3. Working with the device
INSTRUCTIONS FOR USE
a) Loads should be lifted at the lowest possible speed of the winch.
b) Before starting the work with the machine, make sure that the cable is
properly wound on the drum (D).
c) The steel cable should always be taut before lifting the load.
you to lift load twice as big.