Publicidad
Idiomas disponibles
Idiomas disponibles
Before you start
10. Remove the nuts (20).
11. Separate the main body and the backpack housing (21).
12. Remove the bracket (22).
13. Install the control lever (24) in the dial (25).
14. Tighten the nut (26) and knob (27).
15. Install the washer (23).
16. Attach the control lever to the main body.
17. Reinstall the bracket.
18. Install the nut (29) and connector (30) to the control lever rod
(28).
19. Install the connector (30) to the control lever rod.
20. Put the main body onto the backpack housing and tighten
the nuts.
21. Install chemical tank assembly to the body.
22. Insert the control lever rod to the shutter control arm (32) and
fix by pin (33).
23. Refer to page 5, set the shutter control arm and tighten with
nut (31).
3
Publicidad
