THERMODYNE UTILLIAN U8 Manual De Instrucciones página 20

Filling Your Material
You can load your material right on
the bottom surface of the BurstHit 3D
Heating Chamber™. For unrivaled ease
of use, we recommend simply placing
the Multi-Tool, which has your material,
on top of the Carb Cap Base, covering
the BurstHit 3D Heating Chamber™;
there is no need to apply the material
to the BurstHit 3D Heating Chamber™
surface. Stickier material that does not
drip off will melt off the Multi-Tool onto
the BurstHit 3D Heating Chamber™
surface when heat is being generated.
20 Operation of the Device