Publicidad
Idiomas disponibles
Idiomas disponibles
from operating machinery.
Do not pull on the lead of the charger to disconnect it
from the mains power socket.
Do not use an extension cord unless it is absolutely
necessary. The use of an improper extension cord
could cause the risk of fire, electric shock or
electrocution.
Never attempt to connect two chargers together.
Do not charge batteries or use the tool and battery
pack in locations where the temperature may be
below 40°F(4°C) or exceed 104°F(40°C) such as
alongside sheds or metal structures.
If you wish to charge a second battery pack, unplug
the charger from the mains supply and leave it for at
least 15 minutes. After this time you can charge a
second battery pack.
ADDITIONAL SAFETY INSTRUCTIONS RELATED
TO THE BATTERY PACK AND BATTERY SAFETY
Use only the WORKPRO batteries supplied with the
WORKPRO Tool or WORKPRO-approved replace-
ments.
Do not use the battery to power any device other than
the WORKPRO tool it was sold with.
Charge the battery only with the WORKPRO charger
supplied with the tool or WORKPRO-approved
replacements and according to the instructions in the
WORKPRO Instruction Manual.
Do not charge the battery in a place where static
electricity is generated nor let the battery touch
something that is statically charged.
The battery can be stored at temperatures between
40°F(4°C) and 104°F(40°C).
Never store or leave your lithium ion battery in
temperatures over that recommended otherwise fire
may occur.
DO NOT store the Lithium Ion battery anywhere that
the temperature can easily reach higher temperatures
than recommended -this includes garden type sheds,
and vehicles where the inside temperature can climb
to dangerous levels in the direct sunlight and on high
temperature days. THINK BEFORE LEAVING YOUR
LITHIUM ION BATTERY PACK IN STORAGE.
The battery can be charged or operated at tempera-
tures between 40°F(4°C) and 104°F(40°C). NEVER
CHARGE YOU LITHIUM ION BATTERY BELOW OR
ABOVE TEMPERATURES RECOMMENDED
OTHERWISE FIRE OR SERIOUS DAMAGE TO THE
BATTERY PACK MAY OCCUR.
The most suitable temperatures to charge the battery
pack are between 68°F(20°C) -77°F(25°C).
Always allow the battery pack to cool down after
charging, do not place it in a hot environment such as
a metal shed or open trailer left in the sun.
Take care where the tool is stored. Do not store in
areas of corrosive fumes, or salt air or similar
GB
conditions. Try and store the tool in the packaging
supplied with the tool.
Do not dispose of the battery in a fire or put the
battery into a microwave oven, conventional oven,
dryer, or high-pressure container. Under these
conditions, the battery may explode.
Never attempt to open the battery pack, puncture the
battery or subject the battery to strong physical
shock.
If the plastic housing of the battery pack breaks open
or cracks, immediately discontinue its use and do not
recharge it. Ensure the battery pack clip is in good
condition and will not allow the pack to fall free from
the tool. If the clip is damaged or for any reason is not
locking the pack in place, Do Not continue to use.
Stop using the battery if it exhibits abnormal heat,
odour, colour, deformation, or is in an abnormal
condition.
If you detect leakage or a foul odour, it is especially
important to keep the battery away from fire. If
battery liquid leaks onto your skin or clothes, wash
well with clean water immediately. If liquid leaking
from the battery gets into your eyes, do not rub your
eyes. Rinse your eyes well (for at least 10 minutes)
with clean water, and consult a doctor immediately.
Do not use a leaking battery.
Handle batteries with care to avoid shorting the
battery with conducting materials, such as nails,
screws, metal watch bands, rings, bracelets, and
keys. The battery may overheat and could burn you.
After the battery has reached the end of its useful life,
we recommend recycling the materials at your local
municipal council recycling centre. DO NOT attempt
to replace the battery cells in the battery pack, repair
or modify any part of the battery pack assembly.
When recycling, make it nonconductive by applying
insulating tape to the terminals located on the battery.
WHEN TO CHARGE THE BATTERY
New batteries are shipped in a low charged condition
and should be fully charged before Use. The battery
pack can be recharged at any time during use,
provided the pack is not overheated.
If the battery pack starts to cut out due to low
voltage, or previous tasks undertaken can no longer
be performed, it is suggested to stop using the tool
and recharge the battery.
For storage, it is suggested to recharge the battery
between 50% and 75% charge.Charge the device at
least once in 3-6 months to preserve battery life span.
7)Cordless ratchet wrench safety warnings
Hold the power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
5
Publicidad
