Control Panel; Charging The Internal Battery - Battery Extender BE01258 Manual Del Usuario

5. FEATURES
1

6. CONTROL PANEL

DIGITAL DISPLAY
When the clamps are connected to a
vehicle's battery, the digital display indicates
the battery's voltage. When not connected
to a battery, the digital display is used to
indicate the percent of charge of the jump
starter's internal battery. See Display
Messages for a complete list of messages.
NOTE: If the vehicle's battery voltage is
too low to detect, the display will remain
blank; the voltage will not display. A manual
start procedure is required to enable
the jump start function. See Section 8.2,
Starting a Battery with Low Voltage.
NOTE: During charging, the display will
go into sleep mode and will not display
any messages. To turn the display back
on, press any button.

7. CHARGING THE INTERNAL BATTERY

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 3-6 MONTHS, TO KEEP THE
INTERNAL BATTERY FULLY CHARGED
AND PROLONG BATTERY LIFE.
7.1 To reduce the risk of electric shock,
unplug the unit's wall charger from the
outlet before attempting any maintenance
or cleaning. Simply turning off the controls
will not reduce this risk.
7.2 When charging the internal battery, work
in a well ventilated area and do not restrict
the ventilation in any way.
2
3
7
6
16 17
14 15
13
10
11
12
1. BE01258
2. Battery clamp adaptor
4
3. 100V~120V AC wall charger
4. USB/Micro USB connector
5. 12V port adaptor
6. 12V DC car charger
7. Case
8. 12V Input socket for recharging
9. Light
10. USB port
11. 12V DC port
5
12. Jump starter input socket
13. Jump Start button
14. Digital display
15. Charging LED indicator
8
9
16. 12V/USB button
17. Light button
LED INDICATOR
• Green LED solid – The internal battery
is charging.
• Green LED flashing – Charging has
aborted.
• Green LED pulsing – The internal
battery is fully charged.
FUNCTION BUTTONS
7.3 CHECKING THE LEVEL OF THE
INTERNAL BATTERY
To check the internal battery's charge
level, make sure the unit is turned OFF,
then press the
display will show the battery's percent of
charge. A fully charged internal battery will
read 100%. Charge the internal battery if
the display shows it is under 100%.
• 4 •
LIGHT – Operates the LED light
12V/USB – Enables the 12V DC
port and the USB port
JUMP START – Enables the jump
start function
or button. The digital