Rev-A-Shelf 4WCDB-18HFLSC-1 Instrucciones De Instalación página 2

STEP 1
Note: Please revert to the
instruction sheet in the slideset
carton to install your drawer
before using this instruction
sheet.
STEP 2
Pull out the drawer and slide the
USB charging station through the
back of the frame. One in place,
pre-drill the (4) hole locations
and using (4) #6 x 1/2" flat head
screws, screw in the charging
station to the back of the drawer
(See Figure 1).
STEP 3
Place the charging cover over the
charging station and screw in the
piece using (2) #6 x 1/2" oval head
screws (See Figure 2).
STEP 4
Slide the drawer inside the
cabinet. Mark your cable carrier as
shown in Figure 3.
STEP 5
Slide the drawer out and using
the markings from Step 4 screw
in your cable carrier to the back
of the cabinet using (3) #6 x 1/2"
truss head deep thread screws
(See Figure 4).
2
FIG. 2
FIG. 3
FIG. 4
Customer Service: 800-626-1126 | rev-a-shelf.com
FIG. 1
I-4WCDB18USB-1221