mixars serato Manual De Instrucciones página 5

Please visit https://serato.com/hardware/mixars-duo for our
Duo - Serato DJ Quickstart Guide.
Top
18. Channel faders
Adjust the volume level of the corresponding
channel.
19. Crossfader
Switch between Left, Right, or the mix of both
channels.
20. Pads
Use to trigger cue points and samples in Serato DJ.
Bank:
Switch between pad bank 1 (Cues from 1 to 4)
and pad bank 2 (Cues from 5 to 8).
21. Loop / Loop roll
Control the loop and loop roll function in Serato DJ
by turning and pressing the knob. Press and
hold the «SHIFT» button (see 33) for controlling
the loop roll function.
22. FX 1 and FX 2 Control
Adjust the intensity of the corresponding effect by
turning the knob, and turn the effect on and off by
pressing the «ON» Button. Press and hold «SHIFT»
for enabling FX select.
23. Beats
Select the beat fraction for the FX syncronization.
24. Mic / Aux Tone adjust
Adjust the tone of the Mic or Aux input.
25. Mic / Aux Level
Adjust the level of the Mic or Aux input
26. Source Switch
Select the input to be controlled on the
corresponding channel.
Switch between Phono/Line (see 8), Line (see 7) or
Serato - USB (see 10).
27. Trim, EQ, Filter and channel level meters
Trim:
Adjust the overall level for the corresponding
channel.
Hi, Mid, Low:
Adjust the equalizer settings for the corresponding
channel.
Please note that all faders and controls support MIDI
Filter:
Control the analogue filter for the corresponding
channel. Center position: Off
Level meters:
Display the level of the corresponding channel
adjusted via the «Trim» control.
28. Library, Load and Sync controls
Load:
Load a track on the corresponding deck by pressing
the «Load» Buttons.
Library:
Scroll the Library by turning the «Library» knob
and display the next level by pressing it. Hold
«Shift» and press for turning to the previous level.
Sync:
Syncronize a track to another by pressing the
corresponding «Sync» button and turn off the
function by pressing «Sync» while holding «Shift».
29. Headphones and Sampler controls
Mix:
Turn for adjusting between Cue and Master singnal.
Headphones:
Adjust the headphones volume.
Sampler:
Adjust the volume of the sample player.
Cue/Sampler switch:
Select if controlling the Cue Points or the Sample
player with the «Pads» (see 20).
30. Master volume
Adjust the volume of the master level signal.
31. Booth
Adjust the level of the «Booth» output.
32. Cue On/Off
Assign the corresponding channel to the Cue
signal.
33. Shift button
See Points 21, 22, 28. Hold for enabling the
controls:
Loop Roll, FX select, Sync-off and Library-back.
34. Master Level Meters
Display the Master Level Signal.
EN 4