OPERATION
8. Keep control knob depressed for (30) seconds after pilot lights.
Release control knob.
• If the control knob does not pop up when released,
stop and immediately call a qualified service
technician or gas supplier.
• If pilot goes out repeat steps 3 through 7. Wait (1)
minute before attempting to light pilot again. If
after several tries the pilot still goes out, turn the
gas control knob clockwise to the "OFF".
position and call a qualified service technician.
LIGHTING THE BURNER
1. Ensure the pilot is lit. Turn the gas control knob counterclockwise
to the "ON" position (See Fig. 7)
WARNING: If the burner fails to light within 5 seconds, turn the control
knob clockwise to the "PILOT" position. Wait five (5) minutes to clear out
any gas. If you smell any gas STOP! Follow the safety instructions on the
previous page named "WHAT TO DO IF YOU SMELL GAS." If you do not
smell gas, continue on to the next step.
WARNING: If after several tries the pilot still goes out, turn the gas
control knob clockwise to the "OFF" position and call a qualified service
technician.
WARNING: The fireplace screen must be in place when the appliance is operating and,
unless other provisions for combustion are provided, the screen shall have an opening(s) for
introduction of combustion air.
WARNING: Any glass doors shall be completely opened while appliance is in operation.
1. Push in the control knob slightly and turn all the way clockwise
the "OFF" position.
Note: Verify that the unit operates in accordance to these lighting instructions
LIGHTING INSTRUCTIONS (Continued)
TO TURN OFF GAS TO APPLIANCE
14
Fig. 6.5
Fig. 7
, so the white dot is pointing to