Wiesenfield WIE-CCD-200 Manual De Instrucciones página 32

a - Controller cover
b - Controller
c - Self-tapping screws for mounting the controller
d - M4x30 flat head screws for mounting the controller cover
e - Self-tapping screws for mounting guides
f - Bottom rail
g - Guides
h - Door
i - Light sensor cap
Note: a screwdriver (not included) is a tool for assemblying the unit.
Place of installation:
The controller should be mounted on the outer wall of the poultry house (the
•
controller has a light sensor).
The controller should be installed above the hen entrance.
•
It is recommended that the entrance measures max. 22 x 32 cm (width x
•
height).
• The ambient temperature should not fall below -18°C.
Assembly
1) Install the left guide and the left part of the lower rail on the poultry house
with the self-tapping screws.