Lindy 38238 Manual Del Usuario página 5

User Manual
Connecting to the Web-GUI
On the default first page, please select UART if using with RS-232 or Network if using a LAN connection.
For RS-232 Control:
To identify IP information:
▪
Once connected and UART is selected, select the Find Via UART button on the Matrix Switch page.
This will show the IP information of the matrix. This can also be done via the Network Setting page.
To set IP address:
▪
On the Network Setting tab, select Find Via UART to read the current IP address.
▪
Modify the IP address type to Static IP or to Auto IP (DHCP). If set to Static IP, the new IP address,
subnet mask and gateway information can be added.
▪
Select Save Config to save the configuration
▪
Select Find Via UART to confirm the change has been successful
For Network control follow the steps below:
To identify IP address: Once connected and Network is selected, select the Search Device button on the
Matrix Switch page. This will show the IP information of the matrix. This can also be done via the Network
Setting page.
To set IP address:
▪
On the Network Setting tab, select Search Device.
▪
Select the device to configure.
▪
Modify the IP address or address type.
▪
Select Save Config to save the configuration
▪
A success message should now show. Select Search device again to confirm the change has been
successful.
For direct connection, please follow the instructions below
▪
Connect the matrix and PC using Cat.x cable
▪
Please ensure the matrix and PC are in the same network segment (The default IP address of the
matrix is 192.168.0.247, and the default network mask of the matrix is 255.255.255.0)
▪
Run the control software. Please note: If the IP address of the PC has changed after running the
software please reboot the software.
▪
Select Network under CTRL Mode
▪
Select Search device
▪
Select the matrix to control (Once selected, the software will read the network configuration)
▪
Select Disconnected to connect to the matrix
▪
Once a successful connection is made, Status will be changed to Connected. If this is selected again
it will disconnect from the matrix.
English