Publicidad
Idiomas disponibles
Idiomas disponibles
9 Operation
This chapter describes basic operation and precautions associated with this device.
Each time you turn on the device, it will automatically run set by the user.
9.1 Starting the Device
1. Ensure power is supplied to the device. The first screen to display will be the Resvent
logo, within 5 second followed by the patient standby screen (See Figure 1).
Note: Boot buzzer should be "beep". If not, you can't use the equipment and then
contact the supplier for inspection.
2. Put on your mask assembly. Refer to the instructions supplied with the mask.
3. Press the Therapy On/Off key on top of the device to turn on airflow and begin
therapy. The screen will display to patient therapy clean interface (see Figure 2).
4. Make sure that no air is leaking from your mask. If necessary, adjust the mask and
headgear until the air leak stops.
5. If you are using the device in a bed with a headboard, try placing the tubing over the
headboard. This may reduce tension on the mask.
6. Press the Therapy On/Off key again to turn off therapy.
Note:
1. When any power interruption (e.g., blackout) happens during therapy, the device will
resume therapy mode if the power is restored within 60 minutes.
2. Please keep away from incense and candles avoiding catching fire during use.
9.2 Patient Menu Navigation Settings
Patient Menu Navigation Setting including Standby interface shortcut operation、
Therapy interface shortcut operation、Comfort Parameters setting interface、System
setting interface.
9.2.1 Patient Standby Interface
The Patient Standby Interface displays setup menus for the system main features，and
the icons to indicate the current enabled features.
iBreeze CPAP System User Manual
Figure1 Patient Standby Interface
13
Publicidad
