Waferlock C210 Manual De Usuario página 3

Set Up The Programming Card
Default
Before setting the programming card, it is allowed
to use the default pin code (123456#) and any
cards/tags to unlock. After completing the setup
of the programming card, the default pin code
(123456#) will be invalid.
The Programming Card must be linked to the
lock before any other steps can take place.
Note
If 2 short beeps occur with the red light flashing
2 times, the setup was not successful.
Please re-program.
1
Tap the programming card on the reader,
the red light will start flashing for 10 seconds
until "1 long beep sound" followed by the
green light flashing 3 times.
Red
Green X 3
Note
1. Within these 10 seconds, do not remove the
programming card away from the reader.
2. Programming card is used to add/delete user
cards/badges, but not be used to unlock the padlocks.
3. Any MIFARE card will be able to unlock the padlock
before it is programmed.
4. There is only ONE programming card per padlock.
Please keep it safely.
5. You can use one programming card for multiple
padlocks.
10 "beep" sound
1 "beep" sound
Lock Setup with App
Follow below steps to get your lock setup with
WAFERKEY App. You can also use the mobile
App to set up your lock step-by-step and access
installation videos.
1
Download the App by
searching "WAFERKEY"
in the App Store (iOS) or
on Google Play (Android).
2
Open the App, simply use a Third Party Login
or register a WAFERKEY account.
3
Make sure the lock has been already
programmed by the programming card.
Turn on Bluetooth on your smartphone,
stay near the lock and follow the instruction
in the App.
4
Pair the lock in the App and start to use it.
Note
1. The WAFERKEY App works on iPhone with iOS
13.6 or later, or devices with Android 8.0 or later.
2. Be sure to accept any available firmware update.
3. Please refer to the instruction in WAFERKEY App
for more information.
4. Once the lock turns to App Mode, ALL the existing
user access settings (Key Card, Passcode ...) will be
deleted.
DON'T WANT TO USE THE APP?
Please go to Standalone Mode page for manual
programming instructions.
Questions about your new lock?
Let us help you!
support@waferlock.com