Sanus Systems JFV65 Instrucciones De Montaje página 7

Step 5: Add Barrel Nut and Bolt
Place the Bottom (p), with track and channel facing up on a soft surface, which will help prevent scratching. Next, orient the Barrel Nut
(d) so the hole in its side faces the hole in the back of the Top. Proceed to insert the Barrel Nut into the hole as shown in the Detail View
of Diagram 5. Then thread the Barrel Nut Bolt (e) into the hole on the back of the Bottom, as pictured in Diagram 5. Tighten each Barrel
Nut Bolt so that they protrude a 1/4" From the Top.
channel
track
Step 6: Add Bottom
Flip the Bottom (p) so the track and channel are facing down. Align the bottom piece so it is resting on the Panels (q,r,s,t) with the 4 large
holes toward the back as shown in Diagram 6. Insert a Base Bolt (l) through the Bottom and into the appropriate hole in the Panel. See
the Detailed View of Diagram 6 for assistance.
Diagram 5
Diagram 6
Detailed View
d
e
p
Detailed View
l
p