nedis WIFICOL20BK Guia De Inicio Rapido página 5

a
Quick start guide
Outdoor Camera
with light
For more information see the extended
manual online: ned.is/wificol20bk
Intended use
The Nedis WIFICOL20BK is an IP security camera with
a viewing angle of 120 degrees.
If the security camera detects movement, you will
receive a warning message on your phone.
With the app you can watch live video images, play
back, but also listen in and talk back.
Consult the local laws and regulations for this
product before installing and using.
Any modification of the product may have
consequences for safety, warranty and proper
functioning.
Main parts (image A)
Microphone
1
Camera
2
3 PIR sensor
4 Status indicator LED
Bracket mounting
5
screw
Camera mounting
6
screw
The overview screen of the security
camera (image B)
1 Screenshot
Playback
2
PIR
3
Safety instructions
- WARNING
• Ensure you have fully read and understood the
instructions in this document before you install
or use the product. Keep the packaging and this
document for future reference.
• Only use the product as described in this
document.
• Do not use the product if a part is damaged or
defective. Replace a damaged or defective
product immediately.
WIFICOL20BK
Terminal block
7
Wire hole
8
9 Bracket
q Reset button
SD card slot
w
Speaker
e
Plug (6x)
r
4 Record
Night Mode
5
Light
6
• Do not drop the product and avoid bumping.
• This product may only be serviced by a qualified
technician for maintenance to reduce the risk of
electric shock.
• Unplug the product from the power source and
other equipment if problems occur.
• Consult the local laws and regulations for this
product before installing and using.
Mounting the bracket (image C + D)
-
Ensure that the power group that you want to
connect the product to is switched off.
Keep the product in a dust free area when
4
drilling.
1. If there is no power cable available in the desired
location, drill a hole for a power cable in the
desired location.
2. Pull a power cable through the drilled hole.
3. Pull the power cable through the wire hole A
4. Place the bracket A
Follow steps 5-7 for stone/concrete surfaces.
Continue to step 8 for wood surfaces.
5. Use the bracket A
with a pencil.
6. Drill two holes based on the size of the plugs
A .
r
7. Insert the plugs A
Do not overtighten the screws, this will deform the
bracket.
8. Fasten the bracket in the desired location with
the bracket mounting screws A
9. Strip the power cable to expose the wires.
10. Attach the wires to the terminal block A
Mounting the product (image E)
1. Align the camera A
2. Fasten the camera A
the camera mounting screws A
Preparing the product
Use an SD card with a minimum of 8 GB and a
4
maximum of 128 GB.
1. Insert the new SD card into the SD card slot A
2. Turn the power group that the product is
connected to on.
The product switches on automatically.
5
9 in the desired location.
9 to mark the drill locations
into the holes.
r
.
5
7
with the bracket A
2 9
to the bracket A
2 9
6 .
8 .
.
with
w .