Parkside PDM 300 C3 Manual De Instrucciones página 41

7.7 Continuity testing
CAUTION! Make sure that all circuit components, circuits and parts to
be measured are disconnected and discharged. Otherwise the multimeter
could get damaged.
• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the
• Connect the measurement probes [6] to the object to be measured.
• If the resistance is under about 30 Ω, the buzzer sounds and the measured
reading is shown on the display [1].
7.8 Diode test
CAUTION! Make sure that all circuit components, circuits and parts to
be measured are disconnected and discharged. Otherwise the multimeter
could get damaged.
• Connect the black measurement cable to the COM connection [4] and the
red measurement cable to the
• Set the range selector switch [3] to the
• Connect the red measurement probe [6] to the anode of the diode to be
tested and the black measurement probe [6] to the cathode.
• The threshold voltage is shown in volts on the display [1]. If the display [1]
shows "OL", the diode is being measured in the wrong direction or it is
faulty. Carry out a measurement in the opposite direction to check.
OUT INPUT connection [5].
position.
OUT INPUT connection [5].
position.
PARKSIDE PDM 300 C3
English - 39