Volvo Penta IGW Instrucciones De Montaje página 4

Read through the instructions before you begin to work.
Check that all parts are included in the package.
Illustrations can be used for various instructions.
Therefore, items in illustrations can differ from installation
in progress. The essential information is always correct.
This kit contains:
Designation
Information Gateway
(IGW)
Cable tie
Installation instructions
Multilink hub connections (Fig. 1)
• IGW (1) to the multilink hub (3).
• NMEA 2000 (2).
Location
Do not install close to engine heat, seawater strainers and
magnetic fields.
Installation
Secure the unit with the provided cable ties.
Interface (Fig. 2)
Power LED
Constant lit -
The unit is powered up.
IGW LED
Constant lit -
The unit is powered up, but receives no communication
from any side.
Flashes on off repeatedly -
The unit is receiving and transmitting valid external and
MULTILINK data.
Flashes two strobes and then off repeatedly -
The unit is receiving MULTILINK data, but has no external
connection.
Flashes three strobes and then off repeatedly -
The unit is receiving external data, but has no MULTILINK
connection.
Quant Fig Posi-
tion
1 1
3 -
1 -
Output signals from IGW
"Engine parameters rapid PGN 127488"
Engine speed
Engine boost pressure
Powertrim position
"Engine parameters dynamic PGN 127489"
1
Engine oil pressure
-
-
Engine oil temperature
Engine coolant
temperature
Battery voltage
Engine fuel rate
Engine runtime
Engine coolant pressure
Engine fuel delivery
pressure
High coolant temperature
Low oil pressure
Low oil level
Low battery voltage
Low coolant water level
Water in fuel indicator
WarningLevel1 (Amber)
WarningLevel2 (Red)
"Transmission par, dynamic PGN 127493"
Transmission oil pressure
Transmission oil
temperature
Transmission gear
"Fluid level PGN 127505"
Fluid level / fuel
Fluid level / fresh water
Fluid level / oil
"Rudder PGN 127245"
Rudder position
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if
Tricomputer SW is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only for EVC 2.0.
Only for EVC 2.0.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.
Only available if sensor is
installed.