Bresser MeteoTemp W Manual De Instrucciones página 28

Note that the actual range depends on the respective con-
struction materials used for the buildings as well as the re-
spective position of the base unit and the outdoor sensor.
External influences (various radio transmitters and other
sources of interference) can greatly reduce the possible
range. In such cases, we recommend finding other locations
for both the base unit and the outdoor sensor. Sometimes
moving the sensor by just a few centimeters is enough!
8 Setting up power supply
Base station
1.
2.
3.
Remote sensor
4.
5.
6.
9 Automatic time setting
After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approx-
imately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
1.
28 / 96
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.
Press and hold the UP button for 2 seconds to re-initial-
ize RC signal receiving.