Publicidad
Idiomas disponibles
Idiomas disponibles
7
Drive the Screws
a. Place a screw on the driver bit (G).
b. Position the screw in the pilot hole.
c. Drive the screw until fully seated without over driving the screw.
Set-Up and Screw Length Chart For Kreg Screws
Material
Thickness
1/2"
3/4"
Note
Use only SPS style head screws.
Note
The recommended screw length is 3/4" (19 mm), but in some slightly
thicker materials a 1" (25 mm) screw could be used for increased holding
power.
To learn more about selecting and purchasing Kreg Screws,
visit: www.kregtool.com/screws.
Easy-Set
Stop Collar
1/2"
3/4"
G
G
Material Thickness
Stop
1/2"
3/4"
G
G
Screw
Length
3/4" (19 mm)
1-1/4" (32 mm)
9
Publicidad
