Step 1 – Connect USB and Power Cables to the Scanner
1. First install scanner system software on the host PC
2. Connect the USB cable to the scanner and the host PC
3. Connect the Power cable to the scanner and AC outlet
USB CABLE
POWER CABLE
8227 5002-003 September 2019 (Rev 093019)
SmartSource Micro Elite – Setup and Operation
© 2019 Digital Check Corp.
Step 2 – Adjust the Scanner Floor Extender
•
Adjust the floor extender to accommodate
the longest document
Floor Extender
Step 3 – Scanner Start-up, Shut-down & Cleaning Mode
•
Power ON the scanner by pushing and holding down the
Power Button for 2 seconds.
•
When the power light starts blinking, the scanner is ready is ready for
application use.
•
To turn OFF the scanner, push and hold the Power Button until the
Power Button light turns OFF.
•
Cleaning Mode:
Tap the power button down 3 times to engage
Cleaning Mode (LED Turns purple)-insert cleaning card into feed
hopper. Cleaning card automatically scrubs the track. LED color returns
to its prior state after cleaning process is complete, then scanner is
ready to process.
COLOR
Power
PURPLE
Button
Power Button Light
LED
LED
STATE:
STATUS:
USB or Ethernet cable
RED
SOLID
not connected
RED
BLINKING
ERROR
BLUE
BLINKING
Cable is connected
BLUE
SOLID
Actively Scanning
BLINKING
Unit requires cleaning
or SOLID
Page 1 of 16