Digital Check SmartSource Micro Configuración Y Operación

Step 1 - Connect USB (or Ethernet) and Power Cables to the Scanner
1. First install scanner system software on the host PC
2. Connect the USB (or Ethernet) cable to the scanner and the host PC
3. Plug one end of the line cord into the power supply
4. Connect the power supply cable to the scanner
5. Connect the line cord to the AC outlet
USB CABLE
(or Ethernet cable if
Expert Micro Elite
models)
Alternate:
Plug into power
supply
8227 5691-000 August 2016 8227 5691-000 August 2016 8227 6462-000 August 2022 8227 5691-001 November 2016 8227 5691-001 November 2016
SmartSource Micro/Micro Expert Elite W/ Inkjet – Setup and Operation
DC POWER CABLE-plug
into scanner (round end)
Power supply
Step 2 – Installing the Ink Cartridge-optional
LIFT INNER
COVER UP
VERTICALLY
TAB
Insert the cartridge at a slight
angle, nozzles to the rear of
the scanner. Utilize the tab at
the rear of the cartridge for
handling. Then push straight
down from the top. Cartridge
will snap in.
Remove the cartridge by lifting the tab up.
Note: it may be required to wipe the
nozzles gently with a tissue before use.
Open the ink cartridge pouch
and remove the protective
film tape covering the inkjet
nozzles. Make sure that the
nozzles do not contact your
fingers. (or any thing else)
Re-order number:
MS0083
The cartridge top
should be parallel with
the base in the correct
position. Replace the
inner cover.
1 of 4