PowerBoozt PB 2104-S Instrucciones De Uso página 2

Features
 Converter or charger
Power cannot travel from the output
to the input through the PB-2104C.
Purpose
The PB-2104C is a dual-purpose switched converter.
1. Normal converter with a 13.8 V output voltage.
2. A two-step charger with a 24-hour forced charge.
Installation
Step Action
1. Connect the positive (+) of the load to the "Output (+)" of the
PB-2104C.
2. Connect the negative (-) of the load to the "Output (-)" of the
PB-2104C.
3. Connect the positive (+) of the power supply to the "Input (+)"
of the PB-2104C.
4. Connect the negative (–) of the power supply to the "Input (-)"
of the PB-2104C.
Warnings:
The product must only be connected by skilled
fitters/mechanics who are aware of the regulations for working with
high battery voltages.
Using inferior connection material and/or wiring that is too thin may damage the product.
A short circuit between the positive and negative terminals of the battery may severely damage your system.
Always use fuses of the correct value.
Operation
Converter
In setting #1, the PB-2104C functions as a standard converter with a 13.8 V output voltage.
Charger
In settings #2 through #7, the PB-2104C functions as a charger. The output voltage for these settings depends on the
selected programme.
Boost
The boost voltage is between 14.1 V and 14.6 V and can be selected by the user by turning an internal potentiometer. A
30-minute timer will start if the voltage drops 0.8 V below the
will be reduced to the set
Float
float voltage
The is coupled to the selected
There are two events which can cause the PB-2104C to switch from
1. If the voltage drops below 12.8 V for 5 seconds, the
2. If the PB-2104C has been in
General
The PB-2104C has an overvoltage protection in both converter and charger mode.
 Very low power consumption
float voltage
.
boost voltage
float mode
for 24 hours, the
boost voltage
for one minute. After 60 minutes, the voltage
and is between 13.3 V and 13.8 V.
float boost
to
boost mode
will be activated immediately.
boost mode
will be activated automatically.
PB-2104C
 Simple installation
Wiring diagram
.
EN_DE_ES_FR_NL