Educational Insights GeoSafari JR Science Utility Vehicle EI-5094 Guia De Inicio Rapido

Using Your Science Utility Vehicle
Before using for the first time, install 2 AAA batteries as shown
in the diagram on the right side of this page.
To reveal the magnifier, push down on either lever to open the
doors. Focus by turning the spare tire knob on the back of the
truck. To turn on the light, turn the spare tire knob on the front.
Push down on
either lever to
open and reveal
the magnifiers.
Turn knob right for
white light and turn
knob left for
red light.
Focusing knob
Battery Installation and Information
1. Open the battery compartment door by carefully loosening
the screw with a screwdriver.
2. Install two fresh AAA batteries following the illustration
inside the battery compartment.
• D o not use rechargeable batteries.
• D o not mix old and new batteries.
• D o not mix different types of batteries: alkaline, standard
(carbon zinc) or rechargeable (nickel-cadmium) batteries.
• D o not recharge nonrechargeable batteries.
• R emove rechargeable batteries from the toy before
recharging.
• O nly charge rechargeable batteries under adult
supervision.
• O nly use batteries of the same or equivalent type as
recommended.
• I nsert batteries with the correct polarity.
• R emove exhausted batteries from the unit.
• D o not short circuit the supply terminals.
• T o prevent corrosion and possible damage to the
product, we recommend removing the batteries from the
unit if it will not be used for more than two weeks.
3. Close the compartment door and tighten the screw.