Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION & MAINTENANCE
1
4
6
7
OPERATION
4.
Always use the strainer when filling the tank up with liquid.
Mix the solution in a separate container, following the supplier directions on the box.
Pour pre-mixed solution into sprayer and cap.
Place the sprayer on your back and pressurize tank by pumping approximately 25 times.
You will need to pump once each 3 or 4 seconds to maintain the desired spraying pressure.
For a continuous spraying, adjust the shut-off valve lever with the lever lock.
Move the nozzle cap to change the spraying pattern.
5.
MAINTENANCE
Since the sprayer needs little maintenance, if you follow the steps mentioned in this manual its lifespan will be very long.
Do not keep the sprayer with pressure after finishing your spraying job, release the pressure through the nozzle by depressing the trigger,
into a suitable container to re-use later or to dispose of properly.
Pour approximately 1/2 gallon of fresh water in the tank, pressurize and flush, the pumping system by pressing trigger at least 2
minutes, then drain all remaining water.
Carrying straps are made of non-absorbent materials, nevertheless in case of solution spillage, wash them with fresh water to
eliminate all risk of skin irritation.
A unit that has been used with herbicides should never be used to spray insecticides, unless the sprayer has been properly cleaned
and all other chemicals neutralized. Failure to do this could cause you to kill plants that have been sprayed.
Always follow manufacturer's instructions of the chemicals in use to avoid accidents and take maximum advantage of the product.
Store your sprayer clean, empty and dry in a place protected from sunlight.
NOTE:
To keep your sprayer in good condition it is necessary to oil the following parts:
Nozzle O-rings, gun o-rings, piston ring, gasket, breather valve and cap gasket.
9
2
5
3
NOTE:
To ensure good performance use original
"SHINDAIWA" replacement parts
© 09/2022 ECHO Incorporated
SP401BP
99922205754
Publicidad
