Publicidad
Idiomas disponibles
Idiomas disponibles
SYM-
SIGNAL
BOL
DANGER
WARNING
CAUTION
CAUTION
5
PROPOSITION 65
WARNING
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
• Lead from lead-based paints;
• Crystalline silica from bricks and cement and other
masonry products;
• Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
6
INSTALLATION
6.1
UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
English
MEANING
Indicates an imminent-
ly hazardous situation,
which, if not avoided, will
result in death or serious
injury.
Indicates a potential-
ly hazardous situation,
which, if not avoided,
could result in death or
serious injury.
Indicates a potential-
ly hazardous situation,
which, if not avoided, may
result in minor or moder-
ate injury.
(Without Safety Alert
Symbol) Indicates a situa-
tion that may result in
property damage.
• If parts of the machine are damaged, do not use
the machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the
service center.
1.
Open the package.
2.
Read the documentation provided in the box.
3.
Remove all the unassembled parts from the box.
4.
Remove the machine from the box.
5.
Discard the box and packing material in
compliance with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
6.2
INSTALL THE BIT
1
2
1.
Push forward / reverse switch in "neutral" position
to lock the trigger.
2.
Pull the coupler forward and hold in position.
3.
Put bit into coupler.
4.
Release the coupler.
Use only impact quality bits with a locking groove.
Make sure that you attach the bit tight in the coupler
before you use the machine.
6.3
REMOVE THE BIT
1.
Push forward / reverse switch in "neutral" position
to lock the trigger.
2.
Pull the coupler forward and hold in position.
3.
Pull the bit straight out of the coupler.
7
WARNING
WARNING
NOTE
WARNING
EN
Publicidad
