Vmotal Mini Hunting Cam Manual De Instrucciones página 5

Power supply
Before use, install 4x pieces of AA batteries* 1.5V (*included) in the correct
polarity. Open the camera case and remove the battery cover.
Extended Information for Power supply
 The device does not work with a battery voltage lower than 4V.
 The battery life with default video length of 30 seconds will be: 7.5 hours in
day mode or 1.8 hours in night mode & 900 videos in day mode or 200 videos
in night mode.
Inserting the memory card
 The camera has no built-in memory, therefore insert a formated (with FAT32)
MicroSD card** up to 32GB (**not included) for saving files. We suggest to use
class 6 or above high speed card.
Attention: Do not insert the MicroSD card forcibly; refer to the marking on the
camera. The MicroSD card should have same temperature like the ambient
temperature. The camera will be short-circuiting influenced by environment
temperature and humidity. Notice protection for the camera when using it
outdoor.
 If the capacity of MicroSD card is full, the camera will stop recording
automatically. The LEDs will go out (when Endless Capture is OFF).
 Press the edge of the card gently to pop-out the MicroSD card.
Basic Operations
Turn On and Off the camera
Switch the MODE button to "Test/On" to turn on the camera.
Switch the MODE button to "Off" to turn off the camera.
System Setup
Switch MODE button to "Test", then you can set the system parameters.
Press Up/Down button to switch between Video and Photo mode.
Press Menu button to open the setup menu.
Press Up/Down button to scroll through all menus. Then press OK button to
enter the options interface.
Press Up/Down button to scan all options. And press OK button to confirm
options.
Press MENU button again to turn back to last menu or exit the setup menu.
3