Homewerks BFP-272-V5.0 Instrucciones De Instalación

Installation Instructions
Tools needed: Philips Screwdriver (+)
1) If the bath fan is installed, remove the grille by squeezing the
mounting springs and pulling the grille down from the fan
housing. Disconnect the connectors to remove the grille from
the fan housing, as shown in Figure 1.
2) Note the placement of the speaker and how the wires are
installed. You want your installation to look exactly the same
when complete.
3) Using a screwdriver, remove the 8 screws holding the speaker in
place, as shown in Figure 2. Retain the screws.
4) Unscrew the two screws for the bracket along the wire routing.
Removing this bracket will allow the wires to be removed from the
grille. Retain the screws and bracket for re-installation later.
5) Gently slide the speaker and attached wiring out of the grille.
6) Insert the new speaker into the grille. Ensure the speaker
wire is aligned with the bracket so the wire can be tucked
underneath.
7) Align the screw holes. Reinstall the screws removed in step 3.
8) Tuck the speaker wire under the bracket and reattach with the
two remaining screws.
9) Join the connectors for the Bluetooth
from the fan housing to the grille, as shown in Figure 3. Attach
the grille by pinching the mounting springs and inserting them
into the narrow rectangular slots in the fan housing .
10) Turn on the power source. Test the unit.
If not operating properly, please contact customer service at
1-877-319-3757 or send an email message to
Info@HWCares.com.
Homewerks.com
Replacement Bluetooth
speaker and LED light
®
© 2021 Homewerks Worldwide, LLC
Speaker Kit
®
Speaker model BFP-272-V5.0
for Bath Fan model 7130-33-BT
Figure 1
Housin g
slots
Mounting
springs
disconnect the wiring
Figure 2
speaker screws
7130-33-BT grille
Figure 3
Housin g
slots
Mounting
springs
reconnect the wiring
Connectors
Grille
wire
bracket
Connectors
Grille
REV.: 9/1/21