Inserting/Replacing The Batteries; Operation - Omnitronic UHF-215 Manual Del Usuario

Inserting/Replacing the batteries

Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the batteries, remove the old batteries from the battery compartment. Only replace complete
battery-sets.
Caution!
Danger of explosion when battery is replaced improperly.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty batteries in accordance with the instructions of the manufacturer.
Insert the batteries (2 x 1.5 V Mignon batteries, AA) and make sure that the poles are correct.
Replace the battery cover and close it.
With the ON/OFF-switch, you can switch the device on and off. When switching the device on, the red LED
shortly lights up. In this case, the power supply is sufficient.
When the batteries are getting weaker, the red LED is permanently illuminated. In this case, the batteries
have to be replaced.
If the red LED does not light up when switching on, there are either no batteries inserted or the poles are
wrong.
If the microphone is not used, switch it off via the slide switch. If the device will not be used for a longer
period of time, remove the batteries in order to avoid battery leakage.
In order to have a long battery life, you should only use alcaline batteries.
BATTERY DISPOSAL NOTICE
Please dispose of old and used batteries properly.
Batteries are hazardous waste and should not be disposed of with regular domestic waste!
Please take old and used batteries to a collection center near you.

6. OPERATION

With the ON/OFF-switch, you can switch the device on and off. When switching the device on, the LED is
illuminated.
If microphone signals are being received, the RF-LED is illuminated.
17/36 00024570.DOC, Version 1.2