e. Turn on the water supply and re-connect with power. If the RO �lter is replaced,
turn on the faucet and allow the water to run for 30 minutes. If the CP �lter is replaced,
turn on the faucet and allow water to run for 10 minutes.
f. Reset the �lter lifetime according to chapter V.
VII. Precautions
1. Warning
- This is NOT a water puri�er. Always use municipal tap water as the water source.
Do not use water that is microbiologically unsafe or of unknown quality without
adequate disinfection before or after the system.
- This system is not intended for use by persons (including children) with reduced
physical sensory or mental capabilities, or lack of experience and knowledge unless they
have been given supervision or instruction concerning the use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they do
not play with the system.
- Be sure to handle the system gently and carefully. Do not attempt to modify or repair the
system yourself, otherwise, the warranty becomes invalid.
- This device is intended for domestic use only.
- The inlet water temperature of the system should be within 5-38℃. When the inlet water
temperature exceeds 38℃, the �lter could be damaged and become invalid. If the inlet
water temperature is lower than 5℃, it may cause freezing and the parts of the system to
rupture, resulting in water leakage.
- Do not reverse the installation order of the �lter cartridges to avoid affecting the �lter
performance of the system.
- If the system is abnormal or faulty, stop using it immediately. Close the inlet water valve,
and turn on the faucet to empty the system. Events of faults include:
· Leakage
· The product is cracked or damaged
· There is an abnormal sound or burnt smell
· The machine does not work
Please contact consumer care for inspection immediately.
- If not using the system for an extended period, turn off the water supply, and turn on the
faucet to release the internal pressure to avoid damage to the system.
12