Philips AUT7006 Manual Del Usuario página 11

h. Check if the system is installed properly, and
turn on the three-way ball valve.
V. Using the system
1. Before the �rst-time use
a. Connect the system with power. You will hear a beep, and all indicators will light up for
3 seconds. The system �ush will be automatically on. Wipe all the joints and connections
with tissue to check if there is leakage. If the tissue stays dry, it means the system is
installed properly. If there is no further operation after the auto-�ush, the system will
turn into standby mode, and the indicators will be off.
b. After the auto-�ush is completed, turn on the faucet to allow
water to run for 30 minutes to �ush the air and carbon �nes
through the �lters. After that, the system is ready and you can
start to consume the �ltered water.
2. User interface
1
5
When the faucet is turned on, all the indicators will light up to show the �lter lifetime,
the power status, and the error indicator will be off unless there is an error.
2 3 4
6
PC 4-in-1 �lter lifetime indicator
1
RO �lter lifetime indicator
2
Power indicator
3
Error indicator
4
Reset button
5
Flush button
6
9
Hot Cold
RO �ltered
water