Aux In Mode - Work Pro W MULTIPLAYER 12 WEB Manual De Instrucciones

EN
8.1 Selecting stations
To find a station, press Select . The frequency display starts to run up as the unit scans
the FM band. Alternatively, you can scan up or down by pressing and holding the
>> or << buttons or tune manually with quick presses, or by turning the Select
control.
Presets
To store an FM preset, press and hold Preset until the display shows the Save preset
screen. Select one of the 10 presets to save the currently playing station.
To select a preset, press Preset briefly, then select one of the listed preset stations.
When a preset station is playing, it shows Pn (P1, P2 etc) in the bottom right of the
screen.
8.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets data:
8.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-
noise ratio (hiss) from weak stations. To change the scan settings to stop only at stations
with good signal strength, select Menu > Scan setting > Strong stations only? >
Yes.
Audio settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono, select
Menu > Audio setting > FM weak reception: Listen in mono only > Yes.
9

Aux in mode

Aux in mode plays audio from an external source such
as an MP3 player.
To play audio with Aux in mode,
1. Turn the volume low on both the unit and, if
2. Connect the external audio source to the Aux In
3. Either press Mode until the display shows AUX in or select Menu >
4. Adjust the volume of the unit (and, if necessary, the audio source device) as
• If RDS information is available, by default the service name (i.e. station name) is
displayed. You can cycle through further RDS information by pressing Info .
Each time you press Info , another set of information is displayed, cycling
through RDS radio text, RDS programme type, frequency and today's date.
• If no RDS information is available, the currently tuned frequency is shown.
adjustable, the audio source device.
3.5 mm stereo socket.
Main menu > AUX in.
required.
PAG. 25
User Manual/Manual de Instrucciones MULTIPLAYER 12 WEB