AENO SC3 Manual De Instrucciones página 10

Before cleaning the dustbag housing , disconnect it from the vacuum
cleaner housing by pressing the round button on the dustbag housing end
(see figure f). Press the latch to open the bottom lid of the dustbag housing
is opened. Shake dust and other rubbish out of the dustbag housing. The MIF-
filter is to be flushed with water at least once every three months . To do this,
pull the MIF filter out of the dustbag housing (see figure g). Then remove the
filter and the overlay from the funnel of the MIF filter . Rinse the MIF
filter parts with running water and dry them. Then assemble the MIF filter and
insert it into the dustbag housing. Put the dustbag housing back into place in
the vacuum cleaner housing.
The roller brush requires regular cleaning of trapped hair and other rubbish.
To do this, turn the brush lock on the right side (see figure e) by a screwdriver
or knife. Then remove the clogged brush roll and clean it. Use only a special
brush for this. Do not wash the roller with water or cleaning detergents and do
not remove rubbish with your fingers.
Troubleshooting
The vacuum cleaner does not turn on. Possible causes: low charge level,
clogging. Solution: charge the battery, clean the clogs.
Weak suction power. Possible causes: overfilled dustbag, clogged brush.
Solution: clean the dustbag, filters and the brush.
Strong noise, extraneous sounds. Possible causes: clogged metal extension
tube. Solution: clean the tube.
The main brush roll does not rotate. Possible causes: clogging. Solution:
disassemble the main brush, remove the roller and the clog.
The LED indicator lights up blue, then it starts blinking red and the cleaner
shuts off. Possible causes: the battery has overheated or overcooled because
10 aeno.com/documents