Publicidad
Idiomas disponibles
Idiomas disponibles
Using the speaker to answer and end a call
• If you get a call, the speaker will produce a ringtone as an alert.
• Briefly press the Play/pause button to pick up. You may also press the
answer button on your phone to take the call using the speaker.
• To end a call, press the Play/pause button once again. Likewise, you
may also end the call directly using the command on your cell phone.
• When listening to music using your mobile phone, playback will resume
automatically once the call has ended.
• By pressing the Play/pause button twice, the phone will redial the last
number called (on supported devices).
• Press and hold the Play/pause button for about 2 second to send a call
to voice mail.
VI. Auxiliary mode operation
a. First, connect one end of the supplied 3.5mm cable to the auxiliary port
on the speaker and the other end of the cable to the source of choice.
b. Turn on the speaker as it was previously instructed and adjust the volume
to your desired level.
c. Press the Power/mode button twice to switch to Auxiliary-in mode.
d. Start streaming audio files directly from the source of choice.
e. The speaker will remain in this mode until the Power/mode button
is pressed twice to change to the mode of choice or until the
3.5mm cable is disconnected.
Once disconnected, the speaker will switch to Bluetooth
VII. Micro SD™/USB mode operation
Recommendation: Use a USB flash drive or microSD™ card to enable
audio playback from compatible files stored in this type of devices.
a. First, connect a USB flash drive or MicroSD™ card to the corresponding
port of the speaker.
b. The speaker will automatically detect the USB flash drive or microSD™
device and play the audio file. If the devices are not automatically
detected, press the Power/mode button twice to toggle through
the different modes available until you find the one you are looking for.
c. Start streaming audio files directly from the source of choice.
d. As soon as the microSD™/USB devices are disconnected, the speaker
will automatically enter the Bluetooth
VIII. TWS operation
a. When both speakers are in Bluetooth
power button on both speakers to enter the TWS mode.
b. After hearing the prompt, both machines start to pair.
c. When connection is successful, the secondary unit's blue light stays
on and the host unit continues to search until pairing is complete.
d. To revert back from TWS mode, double click the power button again.
®
mode.
mode.
®
search mode, double-click the
®
Publicidad
