Publicidad
Idiomas disponibles
Idiomas disponibles
•
If the refrigerating appliance is left empty for long periods, switch it off. Then defrost and clean it
thoroughly. Let it dry well and leave the door open to prevent mould developing within the appliance.
•
Clean regularly surfaces that can come in contact with food and accessible drainage systems.
•
Store raw meat and fish in suitable containers in the refrigerator, so that they are not in contact with or
drip onto other food.
•
Please store different food according to the compartments or targeted storage temperature of your
purchased items.
•
If the gasket or seal is damaged or deformed, energy consumption will increase. To restore efficiency
replace gasket.
Cleaning, Care & Maintenance
•
Always switch off and disconnect the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Clean the door seal with warm water only.
•
Always wipe dry after cleaning.
Condensation and ice will form with frequent and prolonged opening of the doors.
Operating outside of the recommend temperature range and placing next to a heat source will also increase
the amount of ice and internal/external condensation. If external condensation occurs wipe the surface down
with a cloth.
Excessive ice will result in longer running times that will increase energy consumption and increase the
deterioration of components.
Manual defrost
Nisbets Essentials recommend defrosting the appliance when any frost build up inside the freezer reaches
5mm thick.
1. Turn the freezer off and disconnect it from the power supply.
2. Remove food and shelving basket.
3. Put a water container underneath the drain hole at the left lower part of the front. Then unscrew the 2
drain hole covers (one inside the compartment; the other on the front housing).
4. Let the inside frost melt naturally. Wipe off any residue water.
5. When defrost done, put back the drain hole covers.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault
The appliance is
The unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Unit turns on, but
Too much ice on the evaporator
the temperature
Condenser blocked with dust
is too high/low
Lid not shut properly
Unit is located near a heat source or air
flow to the condenser is being interrupted
DA536_ML_A5_v4_20230206.indb 5
DA536_ML_A5_v4_20230206.indb 5
Probable Cause
Solution
Check unit is plugged in correctly and
switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Defrost the appliance
Clean the Condenser
Check lid is shut and seals are not damaged
Move the freezer to a more suitable location
EN
5
2023/2/6 16:24
2023/2/6 16:24
Publicidad
