Publicidad
Idiomas disponibles
Idiomas disponibles
4.6 ELECTRICAL HEAT INSTALLATION
When it is very cold in winter, and need good
heating performance with temperature
lower than zero°C. So, electrical heat is
suggested to use inside the air conditioner to
improve in automatic way the performance .
‐Remove the insulation sponge and EPP
cover.
‐Remove indoor temperature sensor(NTC) to
outside, and fix it on metal frame.
‐Insert the electrical heat inside the unit, and
fix it well with right position.(P24)
‐Connect the cable from electrical heat to
main PCB. (P25)
‐ Put DIP1 with ON position, PCB is selected
with extra electrical heat function, electrical
heat would work automatically when
outdoor temperature is very low.
4.7 MULTIDIRECTIONAL AIR SYSTEM
This accessory is studied to control air
direction at 360 °C . To install it is easy .
Remove the adhesive tape from the back of
the sponge, and fix the accessory on the top
of the unit. (P26,27)
Rotate the round air flap and control it to the
specified direction as you like.
P24
P26
P27
EN
P23
P25
19
Publicidad
