How To Use The Advanced Functions - INVENTOR EPC-09 Manual Del Propietário

How To Use The Advanced Functions

SLEEP Function
The SLEEP function is used to decrease
energy use while you sleep (if you don't need
the same temperature settings to stay com-
fortable). This function can only be activated
via remote control.
Note: The SLEEP function is not available
in FAN or DRY mode.
SWING Function
Used to stop or start louver movement and set the desired
up/down airflow direction. The louver changes 6 degrees in
angle with each press (on selected models). If you keep it
pressed more than 2 seconds, the louver auto swing feature
is activated.
FOLLOW ME function
The FOLLOW ME function enables the remote
control to measure the temperature at its current
location. When using AUTO, COOL, or HEAT
functions, measuring ambient temperature from
the remote control (instead of from the indoor unit
itself) will enable the air conditioner to optimize
the temperature around you and ensure maxi-
mum comfort.
1. Press FOLLOW ME button to activate function. The
remote control will send temperature signal to the
unit every three minutes.
2. Press FOLLOW ME button again to turn off this
function.
O N /O F F
MO DE
FAN
IO N
S L E E P
SHORTCUT function
• Used to restore the current settings or resume
previous settings.
• Push this button when remote controller is on, the
system will automatically revert back to the pre-
vious settings including operating mode, setting
temperature, fan speed level and sleep feature (if
activated).
• If pressed more than 2 seconds, the system
will automatically restore the current operation
settings including operating mode, setting tem-
perature, fan speed level and sleep feature (if
activated).
14
S HO R T
C U T
T IME R
O N
T E MP
T IME R
O F F
F OLLOW
S W ING L E D
ME