Descargar Imprimir esta página

Saneo D020R2A-10L Manual De Instrucciones página 73

Publicidad

Idiomas disponibles

Idiomas disponibles

Do not place the unit against a wall or near curtains or any other flammable
material.
Do not place the unit near a radiator or other heat sources, or on a heated
carpet or floor.
Do not use this appliance in the kitchen, toilet, or bathroom.
Make sure that the power cord is arranged so that no one can get in the
way of it.
TROUBLESHOOTING
Problem
The device does not
work.
Dehumidification function
does not work.
No air is released.
Possible causes
Has the power cord been
disconnected?
Is the full tank indicator light
flashing? (The tank is full or in
a bad position).
Is the room temperature higher
than 35℃ or lower than 5℃?
Is the air filter clogged?
Is the intake or exhaust duct
obstructed?
Is the air filter clogged?
72/78
Solution
Plug the power cord into
the power outlet.
Drain the water into the
drain tank and reposition
the tank.
The protective device is
activated and the device
cannot be started.
Clean the air filter
according to the
instructions in the manual.
Remove the obstruction
from the exhaust or intake
duct.
Clean the air filter
according to the
instructions in the manual.

Publicidad

loading

Productos relacionados para Saneo D020R2A-10L

Este manual también es adecuado para:

002347