Outsunny 344-065V00 Manual De Instrucciones página 4

STEP 1 Seat Assembly
Step A:
Carefully fold over the
seat armrest followed
by the base as shown
in the diagram.
STEP 2 Frame Swing Assembly
Step B:
Position the back so that it is
at a 90 degree angle to the
base, pushing down on it
until it clicks into place.
You can check
the seat is
aligned as you
will be able to
see through
the holes on
the sides of
the seat.
Step C:
Once the seat has been
aligned, push the two orange
pins firmly into the sides of the
seat until they fully fit into the
backrest. Please note that if
the pins are forced into the
seat when it has not been
aligned, it will cause the pins to
break.
To Attach Rope
Clamps:
Undo the screws on
each hinge and
attach both of the
rope clamps.
Tighten the screws
to finish.