Blue Rabbit Deckswing basic 07211.80 Instrucciones De Montaje página 6

EN
TOOLS REQUIRED
(1) ratchet spanner with cap 13
(2) tape measure
(3) pencil
(4) adhesive tape
(5) wood saw
(6) metal saw
(7) bit PZ2
(8) bit cap 13
(9) square
(10) speed bore bits diameter 10 mm
(11) wood bore bits diameter 3 and 5 mm
(12) drill and/or screwdriver
(13) hammer
(14) sandpaper
(15) stain and brush
WOOD SCREWS
step 1/ To prevent the wood splitting we recommend pre-drilling all wood to be
screwed. Always drill at least 15 mm less deep than the length of the screw.
Pre-drill wood screws with a diameter of 4.5 mm with a 3 mm wood bore bit.
step 2/ First turn the screw one or two millimetres into the plank to be secured,
then press this firmly against the other piece of wood.
step 3/ Tighten the screw with the PZ2 bit supplied in the wood until the head
of the screw is level with the surface of the wood.
COACH SCREWS
step 1/ To prevent the wood splitting we recommend pre-drilling all wood to be
screwed. Always drill at least 15 mm less deep than the length of the screw.
Pre-drill coach screws with a diameter of 8 mm with a 5 mm wood bore bit.
step 2/ Place the flat washer and the bottom of the protective cap over the
shaft of the screw.
step 3/ First turn the screw one or two millimetres into the beam to be secured,
then press this firmly against the other piece of wood.
step 4/ Tighten the screw with the bit cap 13 supplied.
step 5/ Press the top of the protective cap into the opening provided.
BOLTED CONNECTIONS
step 1/ Drill a hole with diameter 10 mm through both planks or beams that
have already been screwed together (see 'wood screws')
step 2/ Hit the drive-in nut with a hammer along the designated side of the
beam in the hole.
step 3/ Place the spring ring, the flat washer and then the bottom part of the
protective cap over the shaft of the bolt.
step 4/ Push the bolt through the hole, and turn by hand several times until
the bolt turns smoothly in the press-in nut.
step 5/ Tighten the bolt with bit cap 13 supplied, until the spring ring is fully
flattened between the head of the bolt and the flat washer.
step 6/ Press the top of the protective cap into the opening provided.
3
ASSEMBLY INSTRUCTIONS
(1)
(6)
(10)
Blue Rabbit ® - www.bluerabbit.be
(2) (3) (4)
(7) (8) (9)
(11) (11) (12)
(13) (14) (15)
(5)