Publicidad
Idiomas disponibles
Idiomas disponibles
ONE-KEY™
To learn more about the ONE-KEY™ functionality
for this tool, go to milwaukeetool.com/One-Key. To
download the ONE-KEY™ app, visit the App Store or
Google Play from your smart device.
ONE-KEY™ Indicator
Solid Blue
Wireless mode is active and ready
to be configured via the ONE-KEY™
app.
Blinking Blue Tool is actively communicating with
the ONE-KEY™ app.
Blinking Red Tool is in security lockout and can
be unlocked by the owner via the
ONE-KEY™ app.
OPERATION
Always remove battery pack before
WARNING
changing or removing accessories.
Only use accessories specifically recommended
for this tool. Others may be hazardous.
To reduce the risk of short circuit, when setting
tool or battery down, do not allow battery to
contact corrosive or conductive fluid.
To reduce the risk of injury, always wear proper
eye protection marked to comply with ANSI Z87.1.
Always wear leather gloves over latex/rubber
gloves to avoid entanglement.
Selecting Speed
Rotate the speed control dial to the desired speed.
The farther the dial is rotated the higher the speed.
Forward/OFF/Reverse Switch
The rotational direction of the cable is set with the
Forward/OFF/Reverse switch.
1. For forward (clockwise) rotation, move the switch
to the
arrow. Check the direction of rotation
before use.
2. For reverse (counterclockwise) rotation, move the
switch to the
arrow. Check the direction of rota-
tion before use.
3. To lock the switch, move the switch to the center
position O. The foot pedal will not work while the
switch is in the center locked position. Always lock
the switch and remove the battery pack before
performing maintenance, changing accessories,
storing the tool and any time the tool is not in use.
Forward
Starting and Stopping
1. To start the tool, move the Forward/OFF/Reverse
switch to either direction and step or kneel on the
foot pedal.
2. To stop the tool, release pressure on the pedal.
OFF
Reverse
Inserting Cable into Drain
1. Transport and set the tool up according to the
instructions under "Transportation" and "Drain
Cleaning Setup".
2. Pull the cable from the tool and
feed at least 2' into the drain.
WARNING! Always wear
leather gloves over latex/
rubber gloves to avoid en-
tanglement.
3. Feed the cable into the
drain until the obstruction is
reached.
4. Pass the chain knocker through the blockage.
5. Set the Forward/OFF/Reverse switch to the
direction and step or kneel on the foot pedal to
begin rotating the cable. WARNING! One person
must control both the cable and the foot pedal. If
the cable stops rotating, the operator must be able
to turn the tool OFF to prevent damage and reduce
the risk of injury.
6. Gradually withdraw the cable, so the chain knocker
can break up the blockage. If the tool binds, re-
lease pressure from the pedal immediately.
7. Repeat steps 4-6 until drain is clear.
Removing Cable from Drain
1. Release pressure on the foot pedal. Allow the
cable to come to a complete stop before removing
from drain.
2. Move the Forward/OFF/Reverse switch to O (OFF)
position.
3. Pull the cable away from the drain.
4. Wipe the exposed cable with a rag and feed it back
into the drum.
5. Before storing the tool, wash the cable and drum
(see "Cleaning" and "Cleaning the Cable" in Main-
tenance).
6
Publicidad
