Publicidad
Idiomas disponibles
Idiomas disponibles
English
1) GENERAL INSTRUCTIONS
- Please read carefully the operating and safety instructions before using our products. These instructions
must be adhered to. Keep the instructions booklet for further check-ups.
- Familiarize yourself with the precise use of the item.
- If the table is handled by unqualified people in an inappropriate way or not according to the intended
purpose, the use of the examination table may be dangerous. Be careful when handling the table as there
is a risk of being trapped by the mobile parts and because of sudden movements.
- Regularly check the table entirely to find any sign of malfunction or damage.
- Every single part or component of the table follows a thorough quality control thus ensuring a smooth
finish. Nevertheless, proceed with caution when handling the table because there might be any corner or
protruding part which might result unintentionally harmful.
- Worn or damaged pieces must be solely replaced by original pieces by the manufacturer depending on
the table model.
- All components parts or accessories should be fitted or fixed in according to the special manufacturer's
instructions. Any spare / replacement component part different to the manufacturer's could be dangerous
for the people involved in the table handling.
* Notice: The use of non original pieces or the alteration of the item will incur in a loss of validity
of the manufacturer's guarantee, instructions and Declaration of Conformity.
The design of the different sections and tilting angles obeys to the standards of specific
profesional areas such as the physiotherapy, rehabilitation and related disciplines, hence the
specific dimensions conforming to these practices.
ATTENTION: Be careful, as there is a risk of entrapment between moving and/or fixed
parts and due to unexpected movements. Only operate the stretcher when there is no
possibility that any part of the body could be trapped and injured while moving the
stretcher up/down or activating the tilt of the component modules.
2) OPERATING INSTRUCTIONS
a) SET UP
Notice: in certain floor surfaces the table legs might leave marks after a prolonged contact. Check the
technical specifications of the floor manufacturer to avoid any trouble.
a) LOAD capacity
This item has been tested to support a MAXIMUM STATIC WEIGHT of 135 Kg evenly distributed all over.
Absolutely avoid leaning on the very edge for support as it may tilt over.
If pressure on a reduced area exceeds the allowed weight, the table upholstery could split up. Keep the
patients from getting on by their knees. The maximum weight limit of every table section is 50 kg.
To get on the table, first lower the table to the required position in order to allow an easier access. The
patient must seat at the middle of the table, raise his legs and lean on his side.
Then, he can lie down. Weight must necessarily be distributed evenly and not concentrated on either side
of the table.
When getting down the table different procedures apply depending on the position of the patient.
Therefore, if he is lying down (prone position) he has to slide gently towards the middle of the table, lean
10
Publicidad
