Reel-Multimedia ReelBox Avantgarde II Serie Manual Rápido página 24

Switching the ReelBox on and off
Switch on the ReelBox with the I/O
mains switch. The start-up progress is
indicated in the display.
Activate the mains switch only in
GB
deep-standby operation, because
otherwise there might be a fault on
the hard disk.
The device features two types of
standby modes:
By oressing the ON/OFF button you
can switch the device into standby/
deep standby mode or reboot it.
The deep-standby mode can be con-
figured in the Setup menu under Basic
Settings.
At „Enable DeepStandby", select the
f
setting „Yes".
At „Go to DeepStandby after (h)",
f
set the time in hours after which the
ReelBox should switch automatically
from standby mode to deep-standby
mode if no button is pressed in the
meantime.
f You can switch the device directly
into deep-standby mode by
f pressing the Exit button during
standby mode.
22
f If you select „0" at „Enable Deep-
Standby", then the ReelBox
switches directly into deep-
standby mode and not only into
standby mode.
Pressing the ON/OFF button switches
the device back on.
You can turn the device off
completely with the I/O mains switch
on the device's back side.
Menu navigation
Selecting menu items
Selecting menu settings
Opening menu items,
OK
confirming selections and
entries
Activate entry /
Exit
Return to previous menu level /
Close menu
Select text entry in lowercase
<
or uppercase
Entering names or values in the
menus