Chasing CM600 Manual Del Usuario página 4

Notice: When the cleaner is working, please do not touch the rotating
components with hands directly.
EN
Notice: Hold the handle when placing the cleaner into water or taking it out
of water, and it is forbidden from pulling the buoyancy cable directly.
Notice: Do not use this product in the swimming pool water added with
liquid flocculating agent or other clarifying agents, otherwise, it may block
or damage filter components of the cleaner.
Notice: Please use the cleaner in the following specified environment:
Working Depth 0.8-5m
pH
7-7.8
Maximum 2 ppm
Chloride
Notice: The cleaner and the control box may power off automatically due to triggering of
high-temperature protection if used in working temperature beyond stipulation or
subject to high-strength and long-time sunshine, which may cause damage to the
product in severe condition.
Connection and Operation
Preparation before cleaning
1
1.1 Place the control box is a shadow and dry place at least 3m away from the
pool edge, to avoid direct sunshine.
05
Working temperature 10-35℃
Salt Maximum 5000 ppm
1.2 Lay out the cleaner' s buoyancy cable in order, and then insert one end of the
buoyancy cable into right interface of the control box, and tighten the nuts.
Note: The control box shall be placed on a table or other platform.
1.3 Hold handle of the cleaner and place it in water slowly, wait until the cleaner
is fully immersed in water and discharges no air, and confirm that the buoyancy
cable is neither knotted nor wound by any obstacle.
Note: It needs to place the buoyancy cable in water appropriately, to guarantee that the
cleaner can clean various regions of the swimming pool, and the cleaner will tilt its head
or fail to perform cleaning if the buoyancy cable is not long enough.
1.4. ①Insert power line on the left of the control box into the power supply
(AC 100-240 V / 50-60 Hz). ②At this time, START/STOP button of the control
box will be always yellow, and the cleaner enters standby status.
1
EN
2
06