Publicidad
Idiomas disponibles
Idiomas disponibles
A
Installing without external opening
Recycling version
Contact your supplier to obtain active carbon
filters to transform the extractor hood into
a recycling hood.
Installing the active carbon filter (cassette)
•
Check that the diameter of the active
carbon filter corresponds the outlet
diameter.
•
If necessary, remove the pre-installed
diameter adapter.
•
Position the active carbon filter on the
outlet and attach it in place by turning
anticlockwise.
Installing the active carbon filter (cut-out)
•
The metal filter has to be removed be-
fore the active carbon filter is installed.
•
To open the metal filter, press on
the locking device and pull the filter
downwards.
•
Place the precut filter on top of the
metal filter. Hold in position using the
metal rods (supplied according to the
model).
•
Replace the metal filter in its original
position.
NOTE
Make sure that the filter is properly attached; otherwise it
could become dislodged and cause a hazard.
The installation of a carbon filter reduces the extraction
power of the hood.
Using the appliance
7
EN
Publicidad
