Publicidad
Idiomas disponibles
Idiomas disponibles
instruction
8
open dining chair
First, push both Release Buttons (G) all the way in to release the Tray
(C).
The Tray (C) will automatically rise slightly.
Fully open the legs
and lift the Back support (I) upwards
Now lift the Tray (C) upwards
place.
Push the front corners of the seat down until you hear a "click" as they
lock in place.
securing the dining chair
Centre the booster seat on a stable chair and do not go over the edge
of the chair.
To level the booster seat, rotate the Anti-slip Feet (F) on the base
before attaching the Leg Attachment Straps (E).
Attach the Leg Attachment Strap (E) to one side of the booster seat,
pass it under the chair and then re-attach it to the opposite side of the
booster seat.
Tighten the Leg Attachment Strap (E) on both sides of the booster
seat to ensure a secure fit.
Open the Rear Mounting Strap (J), loop it around the back of the
chair, fasten the buckle and tighten the strap.
Open the belt buckles, place the child on the booster seat, preferably
with the Tray (C) removed (see the "Removing and fitting the tray"
section below), then fully tighten the Harness Straps (A).
removing and fitting the tray
Remove the Tray (C) by pressing the two Tray Release Levers (D) on
the bottom of the Tray (C) and lifting upwards off the dining chair.
Reverse this process until you hear a "click" to put the Tray (C) back on
to the dining chair.
folding the dining chair
Fully depress both Release Buttons (G) and push the Tray (C) down.
Lift the seat up until it locks out of position.
and the Back support (I)
Close the legs
Tray (C) down until you hear a "click"
IMPORTANT: Normally when you press the Release Buttons (G), the Tray
(C) comes down slightly. But for new products, used for the first few times,
you might need to gently press the Tray (C) This is not a quality issue.
EN
.
until you hear a "click" and it locks in
together and fold the
.
9
EN
Publicidad
